2011

Browse
Opens the Select Reference File dialog (a standard file selection dialog box on
page 1295).
Select one of more sheets from the DWF file
Displays all of the sheets that are found in the DWF file. If the DWF file only
contains a single sheet, that sheet is listed. You can select multiple sheets by
holding the Shift key or the Ctrl key while selecting the sheets to attach. If
you hover over the preview, the file name displays.
Path Type
Select the full (absolute) path, the relative path to the DWF file, or No Path,
the name of the DWF file (the DWF file must be located in the same folder as
the current drawing file).
NOTE The Path Type group is disabled when you’re attaching a DWF or DWFx
file that is stored on the Vault client server. This information is automatically entered
by the Vault.
Insertion Point
Specifies the insertion point for the selected DWF file. Specify On-Screen is
the default. The default insertion point is 0,0,0.
Specify On-Screen Directs input at the Command prompt or the pointing
device. If Specify On-Screen is cleared, enter the insertion point in X, Y, and
Z.
Scale
Specifies the scale factor of the selected DWF underlay.
If
INSUNITS is set to “unitless” or if the underlay does not contain resolution
information, the scale factor becomes the underlay width in AutoCAD units.
If INSUNITS has a value such as millimeters, centimeters, inches, or feet, and
the underlay has resolution information, the scale factor is applied after the
true width of the underlay in AutoCAD units is determined.
Specify On-screen Allows you to input at the Command prompt or the
pointing device. If Specify On-Screen is cleared, enter a value for the scale
factor. The default scale factor is 1.
Scale Factor Field Enter a value for the scale factor. The default scale factor
is 1.
Rotation
Specifies the rotation angle of the selected DWF underlay.
Attach DWF Underlay Dialog Box | 697