2011

the positions available for that angle. Toggle unlocks the cursor movement
for the angle, and you can use the cursor to rotate the camera.
Enter Angle in XY Plane from X Axis Sets the position at an angle in the XY
plane relative to the X axis of the current UCS. This angle measures from -180
to 180 degrees. A rotation angle of 0 degrees looks down the X axis of the UCS
toward the origin.
The illustration shows the camera rotating to the left from its initial position,
leaving its angle from the XY plane unchanged.
Toggle (Angle From) Switches between two angle input modes. Entering an
angle at the Command prompt locks the cursor movement so you see only
the positions available for that angle. Toggle unlocks the cursor movement
for the angle, and you can use the cursor to rotate the camera.
Target
Specifies a new position for the target by rotating it around the camera. The
effect is like turning your head to see different parts of the drawing from one
vantage point. Two angles determine the amount of rotation.
Enter Angle from the XY Plane
Enter Angle from the XY Plane on page 687
Toggle (Angle In)
Toggle (Angle In) on page 687
Enter Angle in XY Plane from X Axis
Enter Angle in XY Plane from X Axis
on page 688The illustration shows the effect of moving the target point from
left to right, leaving its angle from the XY plane unchanged.
688 | Chapter 5 D Commands