2011

Sets the Palette Location mode to Cursor-dependent. In cursor-dependent
mode, the Quick Properties palette displays in a location relative to where you
selected the object. (
QPLOCATION on page 2477 system variable)
Quadrant:
Specifies the relative location to display the Quick Properties palette. You can
select one of the four quadrants top-right, top-left, bottom-right, or bottom-left.
Distance in Pixels:
Sets the distance in pixels when Cursor is selected under the Palette Location
modes. You can specify values in the range of 0 to 400 (only integer values).
Static
Sets the location mode to Static. (
QPLOCATION on page 2477 system variable)
Palette Behavior
Sets the behavior of Quick Properties palette.
Collapse Palette Automatically
Enables the Quick Properties palette to display only a specified number of
properties in the idle state.
Minimum Number of Rows:
Sets the minimum number of rows for the Quick Properties palette to display
in the collapsed idle state. You can specify values in the range of 1 to 30 (only
integer values).
Selection Cycling Tab (Draft Settings Dialog Box)
Selection cycling allows you to select objects that are overlapping. You can
configure the display settings of the selection cycling list box. To filter the
type of subobjects displayed (vertices, edges, or faces) use the
SUBOBJSELECTIONMODE on page 2532system variable.
Drafting Settings Dialog Box | 677