2011

Summary
Each selected dimension is highlighted in turn, and prompts for association
points appropriate for the selected dimension are displayed.
A marker is displayed for each association point prompt.
■ If the definition point of the current dimension is not associated to a
geometric object, the marker appears as an X
■ if the definition point is associated, the marker appears as an X inside a
box.
NOTE The marker disappears if you pan or zoom with a wheel mouse.
List of Prompts
The following prompts are displayed.
Select dimensions to reassociate: Select dimension objects
Press Esc to terminate the command without losing the changes that were
already specified. Use UNDO to restore the previous state of the changed
dimensions.
The prompts for the different types of dimensions are:
Linear Specify first extension line origin or [Select object] <next>: Specify an
object snap location, enter s and select a geometric object, or press Enter to skip to
the next prompt
Specify second extension line origin <next>: Specify an object snap location, or
press Enter to skip to the next dimension object, if any
Aligned Specify first extension line origin or [Select object] <next>: Specify an
object snap location, enter s and select a geometric object, or press Enter to skip to
the next prompt
Specify second extension line origin <next>: Specify an object snap location, or
press Enter to skip to the next dimension object, if any
Angular (Three Point) Specify angle vertex or [Select arc or circle] <next>:
Specify an object snap location, enter s and select an arc or a circle, or press Enter to
skip to the next prompt
Specify first angle endpoint <next>: Specify an object snap location or press Enter
to skip to the next prompt
Specify second angle endpoint <next>: Specify an object snap location or press
Enter to skip to the next dimension object, if any
608 | Chapter 5 D Commands