2011

Conversion Units
Matches the DWF files’s drawing units to the master units and sub-units
specified in the DGN file. For example, if the DGN file has master units set to
meters, and sub-units set to millimeters, and you want the DWG to be set to
millimeters, select sub-units in the Attach DGN Underlay dialog box.
Master Units Matches the DWG drawing units to the master units set in the
DGN file.
Sub Units Matches the DWG drawing units to the sub- units set in the DGN
file.
Path Type
Selects the full (absolute) path, the relative path to the DGN file, or No Path,
the name of the DGN file (the DGN file must be located in the same folder as
the current drawing file).
NOTE The Path Type group is disabled when you’re attaching a DGN file that is
stored on the Vault client server. This information is automatically entered by the
Vault.
Insertion Point
Specifies the insertion point for the selected DGN file. Specify On-Screen is
the default. The default insertion point is 0,0,0.
Specify On-Screen Directs input at the Command prompt or the pointing
device. If Specify On-Screen is cleared, enter the insertion point in X, Y, and
Z.
X Sets the X coordinate value.
Y Sets the Y coordinate value.
Z Sets the Z coordinate value.
Scale
Specifies the scale factor of the selected DGN underlay.
If
INSUNITS is set to “unitless” or if the underlay does not contain resolution
information, the scale factor becomes the underlay width in AutoCAD units.
If INSUNITS has a value such as millimeters, centimeters, inches, or feet, and
the underlay has resolution information, the scale factor is applied after the
true width of the underlay in AutoCAD units is determined.
Specify On-screen Allows you to input at the Command prompt or the
pointing device. If Specify On-Screen is cleared, enter a value for the scale
factor. The default scale factor is 1.
Attach DGN Underlay Dialog Box | 533