2011

Specify radius of dish or [Diameter]: Specify a distance or enter d
Radius Defines the dish by its radius.
Enter number of longitudinal segments for surface of dish <16>: Enter a value
greater than 1 or press Enter
Enter number of latitudinal segments for surface of dish <8>: Enter a value
greater than 1 or press Enter
Diameter Defines the dish by its diameter.
Specify diameter of dish: Specify a distance
Enter number of longitudinal segments for surface of dish <16>: Enter a value
greater than 1 or press Enter
Enter number of latitudinal segments for surface of dish <8>: Enter a value
greater than 1 or press Enter
Dome
Creates the upper half of a spherical polygon mesh.
Specify center point of dome: Specify a point (1)
Specify radius of dome or [Diameter]: Specify a distance or enter d
Radius Defines the dome by its radius.
Enter number of longitudinal segments for surface of dome: Enter a value greater
than 1 or press Enter
Enter number of latitudinal segments for surface of dome <8>: Enter a value
greater than 1 or press Enter
Diameter Defines the dome by its diameter.
Specify diameter of dome: Specify a distance
Enter number of longitudinal segments for surface of dome <16>: Enter a value
greater than 1 or press Enter
Enter number of latitudinal segments for surface of dome <8>: Enter a value
greater than 1 or press Enter
8 | Chapter 1 3D Commands