2011

If the polyline includes segments that are too short to accommodate the
chamfer distance, those segments are not chamfered.
Distance
Sets the distance of the chamfer from the endpoint of the selected edge.
If you set both distances to zero, CHAMFER extends or trims the two lines so
they end at the same point.
Angle
Sets the chamfer distances using a chamfer distance for the first line and an
angle for the second line.
Trim
Controls whether CHAMFER trims the selected edges to the chamfer line
endpoints.
NOTE Trim sets the TRIMMODE system variable to 1; No Trim sets TRIMMODE
to 0.
If the TRIMMODE system variable is set to 1, CHAMFER trims the intersecting
lines to the endpoints of the chamfer line. If the selected lines do not intersect,
316 | Chapter 4 C Commands