2011

Access Methods
Panel
Ribbon: Block Editor contextual tab ➤ Action Parameters panel
Summary
You can use the bparameter command only in the
Block Editor on page 231.
A parameter defines custom properties for the block reference. After you add
a parameter, you must associate an action with the parameter to make the
block dynamic.
List of Prompts
The following prompts are displayed.
Enter parameter type [
Alignment/Base on page
264/
pOint/Linear/Polar/XY/Rotation/Flip/“Visibility”/looKup] <last>: Enter a
parameter type
Alignment
Button
Block Editor contextual tab ➤ Action Parameters panel ➤ Alignment
Rotates the block reference about a point to align with other objects in the
drawing.
Specify Base Point of Alignment Specifies the grip about which the block
reference will rotate to align with another object in the drawing.
Name Sets the Name custom property for this parameter.
Specify Alignment Direction Determines the angle of alignment for the
block reference.
Type Determines whether the block reference will align tangent or
perpendicular to objects in the drawing.
BPARAMETER | 263