2011

Vertical (BCPARAMETER on page 217) Creates a vertical constraint parameter
by picking two constraint points. Valid objects include lines and polyline
segments.
Aligned (
BCPARAMETER on page 217) Creates an aligned constraint parameter
using one of the following ways.
■ Selects a point and a line object. The aligned constraint controls the
distance between a point and the closest point on a line.
■ Selects two line objects. The lines are made parallel and the aligned
constraint controls the distance between the two lines.
Radius (
BCPARAMETER on page 217) Creates a radial constraint parameter
for a circle, arc, or polyline arc segment.
Diameter (
BCPARAMETER on page 217) Creates a diameter constraint
parameter for a circle, arc, or polyline arc segment.
Angular (BCPARAMETER on page 217) Creates an angular constraint
parameter by picking two lines or polyline segments or an arc. It is similar to
an angular dimension.
Convert (
BCPARAMETER on page 217) Converts the dimensional constraints
to constraint parameters.
Block Table Displays a dialog box to define variations of a block.
Constraint Settings Sets preferences in behavior when displaying dimensional
constraints.
Manage Panel
Delete Constraints Removes all geometric and dimensional constraints from
a selection set of objects.
Construction Geometry Converts geometry into construction geometry.
Block Constraint Status Turns the constraint display status on and off and
controls the shading of objects based on their constraint level.
Parameters Manager Controls the associative parameters used in the drawing.
Authoring Palettes Opens the Block Authoring Palettes window in the Block
Editor.
Block Editor Settings Displays the Block Editor Settings dialog box.
228 | Chapter 3 B Commands