2011

Minimum curvature (evaluates the minimum curvature of the
U and V surface curvature values)
3
VSADRAFTANGLEHIGH
Quick Reference
See also:
■
ANALYSISOPTIONS on page 112
■ ANALYSISOPTIONS - Draft Analysis Tab on page 115
RealType:
DrawingSaved in:
3Initial value:
Sets the value at which a model displays as green during draft analysis
(
ANALYSISDRAFT on page 111).
Draft angle is the angle in degrees between the surface normal and the UCS
plane. High value is set by this system variable.
Surface is parallel to the UCS with surface normal fa-
cing the opposite direction as the construction plane
-90
Surface is perpendicular to the construction plane0
Surface is parallel to the construction plane with sur-
face normal facing the same direction as the UCS
90
VSADRAFTANGLELOW
Quick Reference
See also:
■
ANALYSISOPTIONS on page 112
■ ANALYSISOPTIONS - Draft Analysis Tab on page 115
2586 | Chapter 47 V System Variables