2011

IntegerType:
RegistrySaved in:
1Initial value:
Determines whether object snapping is active for geometry in DWF or DWFx
underlays that are attached to the drawing.
The
UOSNAP system variable overrides the DWFOSNAP setting.
Object snapping is disabled for geometry in all DWF or
DWFx underlay attachments in the drawing
0
Object snapping is enabled for geometry in all DWF or
DWFx underlay attachments in the drawing
1
DWGCHECK
Quick Reference
See also:
■ Open a Drawing
IntegerType:
RegistrySaved in:
1Initial value:
Checks drawings for potential problems when opening them.
If a drawing that you try to open has a potential problem,
you are warned before the drawing is opened.
0
If a drawing that you try to open has a potential problem,
or if it was saved by an application other than one released
1
by Autodesk or based on RealDWG, you are warned before
the drawing is opened.
If a drawing that you try to open has a potential problem,
you are notified at the Command prompt.
2
If a drawing that you try to open has a potential problem,
you are notified at the Command prompt. If the drawing
3
has a potential problem and the drawing was saved by
2290 | Chapter 31 D System Variables