2011

Use <> to indicate placement of the text in relation to the dimension value.
For example, enter <>mm to display a 5.0 millimeter radial dimension as
"5.0mm". If you entered mm <>, the dimension would be displayed as "mm
5.0". Use the <> mechanism for angular dimensions.
DIMRND
Quick Reference
See also:
■ Round Off Dimension Values
RealType:
DrawingSaved in:
0.0000Initial value:
Rounds all dimensioning distances to the specified value.
For instance, if DIMRND is set to 0.25, all distances round to the nearest 0.25
unit. If you set DIMRND to 1.0, all distances round to the nearest integer.
Note that the number of digits edited after the decimal point depends on the
precision set by DIMDEC. DIMRND does not apply to angular dimensions.
DIMSAH
Quick Reference
See also:
■ Customize Arrowheads
SwitchType:
DrawingSaved in:
OffInitial value:
Controls the display of dimension line arrowhead blocks.
Use arrowhead blocks set by DIMBLKOff
Use arrowhead blocks set by DIMBLK1 and DIMBLK2On
2248 | Chapter 31 D System Variables