2011

DIMDLI
Quick Reference
See also:
■ Control Dimension Lines
RealType:
DrawingSaved in:
0.3800 (imperial) or 3.7500 (metric)Initial value:
Controls the spacing of the dimension lines in baseline dimensions.
Each dimension line is offset from the previous one by this amount, if
necessary, to avoid drawing over it. Changes made with DIMDLI are not
applied to existing dimensions.
DIMDSEP
Quick Reference
See also:
■ Control the Display of Dimension Units
Single-characterType:
DrawingSaved in:
. (imperial) or , (metric)Initial value:
Specifies a single-character decimal separator to use when creating dimensions
whose unit format is decimal.
When prompted, enter a single character at the Command prompt. If
dimension units is set to Decimal, the DIMDSEP character is used instead of
the default decimal point. If DIMDSEP is set to NULL (default value, reset by
entering a period), the decimal point is used as the dimension separator.
2238 | Chapter 31 D System Variables