2011

DELOBJ
Quick Reference
See also:
■ Create and Combine Areas (Regions)
■ Create Solids and Surfaces from Lines and Curves
IntegerType:
RegistrySaved in:
3Initial value:
Controls whether geometry used to create 3D objects is retained or deleted.
If the
SURFACEASSOCIATIVITY on page 2537 system variable is set to 1, the
DELOBJ setting is ignored.
All defining geometry is retained.0
Deletes profile curves, including those used with the EX-
TRUDE, SWEEP, REVOLVE, and LOFT commands. Removes
1
all defining geometry for CONVTOSOLID on page 363,
CONVTOSURFACE on page 366, CONVTONURBS, and
CONVTOMESH commands. Cross sections used with the
LOFT command are also deleted.
Deletes all defining geometry, including paths and guide
curves used with the SWEEP and LOFT commands.
2
Deletes all defining geometry, including paths and guide
curves used with the SWEEP and LOFT commands if the
3
action results in a solid object. Removes all defining geo-
metry for CONVTOSOLID, CONVTOSURFACE, CONVTON-
URBS, and CONVTOMESH commands.
Displays prompts to delete profile curves, including those
used with the EXTRUDE, SWEEP, REVOLVE, and LOFT
-1
commands. Prompts to remove cross sections used with
the LOFT command.
The original geometry for CONVTOSOLID, CONVTOSUR-
FACE, and CONVTOMESH commands is removed without
prompting.
2216 | Chapter 31 D System Variables