2011

Uniform Scale
Sets the Y and X scale factors as the same as Z.
Insertion Point
Specify On-Screen
Allows you to input at the Command prompt or the pointing device.
X
Sets the X coordinate value.
Y
Sets the Y coordinate value.
Z
Sets the Z coordinate value.
Path Type
Select the full (absolute) path, the relative path to the external reference file,
or No Path, the name of the external reference (the file must be located in the
same folder as the current drawing file).
Rotation
Specify on-screen
If Specify On-Screen is selected, you may wait until you exit the dialog box
to rotate the object with your pointing device or at the Command prompt.
Angle
If Specify On-Screen is cleared, enter the rotation angle value in the dialog
box.
Block Unit
Displays information about the block units.
Unit
Displays the specified INSUNITS value for the inserted block.
Factor
Displays the unit scale factor, which is calculated based on the INSUNITS value
of the block and the drawing units.
Show Details
Displays the external reference file paths.
2108 | Chapter 24 X Commands