2011

List of Prompts
The following prompts are displayed.
Specify
insertion point on page 2098 or [Scale on page 2098/X on page 2098/Y on
page 2098/
Z on page 2098/Rotate on page 2098/PScale on page 2099/PX on page 2099/PY
on page 2099/PZ on page 2099/PRotate on page 2099]: Specify a point or enter an option
Insertion Point
Places a copy of the metafile with its base point at the specified insertion
point.
X Scale Factor Sets the X and Y scale factors.
All X and Y dimensions of the metafile are multiplied by the X and Y scale
factors supplied. The metafile is rotated by the angle specified, using the
insertion point as the center of rotation.
Corner Defines the X and Y scales at the same time, using the insertion point
and another point as the corners of a box. The X and Y dimensions of the box
become the X and Y scale factors. The insertion point is the first corner.
The rotation angle sets the angle of the WMF file.
XYZ Scales the metafile in all three dimensions.
If you enter c, you specify a corner point. The specified point and the insertion
point determine the X and Y scale factors for the WMF file.
The rotation angle sets the angle of the WMF file.
Scale
Sets the scale factor for the X, Y, and Z axes. The scale for the Z axis is the
absolute value of the specified scale factor.
X
Sets the X scale factor.
Y
Sets the Y scale factor.
Z
Sets the Z scale factor.
Rotate
Sets the angle of insertion for the WMF file.
■
X Scale Factor on page 2098
■ Corner on page 2098
■ XYZ on page 2098
2098 | Chapter 23 W Commands