2011

Entering a positive value draws the height along the positive Z axis of the
current UCS. Entering a negative value draws the height along the negative
Z axis.
Center
Creates the wedge by using a specified center point.
Cube Creates a wedge with sides of equal length.
Length Creates a wedge with length, width, and height values you specify.
The length corresponds to the X axis, the width to the Y axis, and the height
to the Z axis. If you pick a point to specify the length, you also specify the
rotation in the XY plane.
Cube
Creates a wedge with sides of equal length.
2094 | Chapter 23 W Commands