2011

WEDGE
Quick Reference
See also:
■ Create a Solid Wedge
Creates a 3D solid wedge.
Access Methods
Button
Ribbon: Home tab ➤ Modeling panel ➤ Wedge
Menu: Draw ➤ Modeling ➤ Wedge
Toolbar: Modeling
Summary
The direction of the taper is always in the positive X-axis direction of the UCS.
List of Prompts
The following prompts are displayed.
Specify first corner or [
Center on page 2094]: Specify a point or enter c for center
Specify other corner or [
Cube on page 2094/Length on page 2095]: Specify the other
corner of the wedge or enteran option
If the other corner of the wedge is specified with a Z value that differs from
the first corner, then no height prompt is displayed.
Specify height or [2Point on page 2095] <default>: Specify the height or enter 2P
for the 2 Point option
WEDGE | 2093