2011

WEBLIGHT
Quick Reference
See also:
■ Overview of Weblights
Creates a web light
Access Methods
Button
Ribbon: Render ➤ Lights panel ➤ Create Light ➤ Weblight.
Toolbar: Lights
List of Prompts
The following prompts are displayed.
Specify source location <0,0,0>: Enter coordinate values or use the pointing device
Specify target location <1,1,1>: Enter coordinate values or use the pointing device
Enter an option to change [
Name on page 2090/Intensity factor on page 2090/Status
on page 2090/Photometry on page 2091/weB on page 2091/shadoW on page
2092/
filterColor on page 2092/eXit on page 2092] <eXit>:
NOTE The LIGHTINGUNITS system variable must be set to a value other than 0
to create and use weblights.
Name
Specifies the name of the light.
Intensity Factor
Sets the intensity or brightness of the light.
Status
Turns the light on and off. If lighting is not enabled in the drawing, this setting
has no effect.
2090 | Chapter 23 W Commands