2011

Sets the included angle between the base points of the arrayed objects and
the center of the array. Enter a positive value. The default direction value is
90.
NOTE You can choose the Pick buttons and use the pointing device to specify
the values for Angle to Fill and Angle Between Items.
Pick Angle to Fill Temporarily closes the Array dialog box so that you can
define the included angle between the base points of the first and last elements
in the array. ARRAY prompts you to select a point relative to another point
in the drawing area.
Pick Angle Between Items Temporarily closes the Array dialog box so that
you can define the included angle between the base points of the arrayed
objects and the center of the array. ARRAY prompts you to select a point
relative to another point in the drawing area.
Rotate Items as Copied
Rotates the items in the array, as shown in the preview area.
More/Less
Turns the display of additional options in the Array dialog box on and off.
When you choose More, additional options are displayed, and the name of
this button changes to Less.
Object Base Point
Specifies a new reference (base) point relative to the selected objects that will
remain at a constant distance from the center point of the array as the objects
are arrayed. To construct a polar array, ARRAY determines the distance from
the array's center point to a reference (base) point on the last object selected.
The point used depends on the type of object, as shown in the following table.
Base point settings by object
Default base pointObject type
Center pointArc, circle, ellipse
First cornerPolygon, rectangle
Starting pointDonut, line, polyline, 3D polyline, ray, spline
Insertion pointBlock, paragraph text, single-line text
MidpointConstruction lines
Array Dialog Box | 153