2011

When you specify the center point, the torus is positioned so that its central
axis is parallel to the Z axis of the current user coordinate system (UCS). The
torus is parallel to and bisected by the XY plane of the current workplane.
Specify
radius on page 1962 or [diameter on page 1962] <default>: Specify a distance
or enter d
3P (Three Points)
Defines the circumference of the torus with three points that you specify. The
three specified points also define the plane of the circumference.
2P (Two Points)
Defines the circumference of the torus with two points that you specify. The
plane of the circumference is defined by the Z value of the first point.
TTR (Tangent, Tangent, Radius)
Defines the torus with a specified radius tangent to two objects. The specified
tangency points are projected onto the current UCS.
Radius
Defines the radius of the torus: the distance from the center of the torus to
the center of the tube. A negative radius creates a solid shaped like an American
football.
Radius Defines the radius of the tube.
Diameter Defines the diameter of the tube.
Diameter
Defines the diameter of the torus.
■ Radius on page 1962
■ Diameter on page 1962
1962 | Chapter 20 T Commands