2011

If TEXTED is set to 2, the In-Place Text Editor is displayed. When creating
text, you can click anywhere in a drawing to create a new text block. You can
also use the keyboard to move among text blocks (for example: for new text
created using the
TEXT command, you can navigate through text groups by
pressing Tab or Shift+Tab, or edit a group of text lines by pressing Alt and
clicking each text object.)
NOTE Text that would otherwise be difficult to read (if it is very small, very large,
or is rotated) is displayed at a legible size and is oriented horizontally so that you
can easily read and edit it.
You can enter special characters and format text by entering
Unicode strings
and control codes.
Use -TEXT to
honor the TEXTEVAL system variable.
List of Prompts
The following prompts are displayed.
Current text style: <current> Current text height: <current> Annotative: <current>
Specify
start point on page 1933 of text or [Justify on page 1933/Style on page 1936]:
Specify a point or enter an option
Start Point
Specifies a start point for the text object. Enter text in the In-Place Text Editor
for single-line text.
The SpecifyHeight prompt is displayed only if the current text style is not and
does not have a fixed height.
The Specify Paper Text Height prompt is displayed only if the current text
style is annotative.
Justify
Controls justification of the text.
You can also enter any of these options at the Specify Start Point of Text
prompt.
Align Specifies both text height and text orientation by designating the
endpoints of the baseline.
TEXT | 1933