2011

First and Second Surface or Region Specifies the first and second surfaces or
regions.
Radius Specifies fillet radius. Use the Fillet grip or enter a value to change the
radius. You cannot enter a value that is smaller than the gap between the
surfaces. If no radius value is entered, the FILLETRAD3D on page 2321 system
variable value is used.
Trim Surface Trims the original surfaces or regions to the edges of the fillet
surface.
Expression Enter a formula or equation to specify the fillet radius. See
Constrain a Design with Formulas and Equations.
SURFNETWORK
Quick Reference
See also:
■ Create Network Surfaces
Creates a surface in the space between several curves in the U and V directions
(including surface and solid edge subobjects).
Access Methods
Button
Ribbon: Surface tab ➤ Create panel ➤ Network
Menu: Draw ➤ Modeling ➤ Surfaces ➤ Network
Toolbar: Surface Creation
Summary
A network surface can be created between a network of curves or between the
edges of other 3D surfaces or solids.
SURFNETWORK | 1879