2011

When you choose End Tangency, you are prompted for the last tangent of
the last entered fit point.
Tolerance Specifies the distance from specified fit points that the spline must
pass through. Tolerance applies to all fit points except start and endpoints.
Options for Splines with Control Vertices
Options specific to control vertices are displayed when the Method option is
set to CV. (
SPLMETHOD on page 2525 system variable)
Degree Sets the maximum number of “bends” you can get in each span; the
degree can be 1, 2 or 3. There will be one more control vertex than the number
of degrees, so a degree 3 spline has 4 control vertices.
SPLINE | 1833