2011

Method
Controls whether the spline is created with fit points or control vertices. The
options differ depending on whether you select
Options for Splines with Fit
Points
on page 1832 or Options for Splines with Control Vertices on page 1833.
Fit Draw a spline by specifying fit points.
Changing the Method updates the SPLMETHOD on page 2525 system variable.
Control Points Draw a spline by specifying control vertices.
This is the preferred method if you are creating geometry to use with 3D
NURBS surfaces. Changing the Method updates the SPLMETHOD on page 2525
system variable.
1830 | Chapter 19 S Commands