2011

World Uses the XY plane of the WCS to create a profile view.
Enter the name of the UCS you want to use and the scale of your view. Entering
a scale is equivalent to zooming your viewport by a factor relative to paper
space.
The center is based on the current model space extents.
?—List Named UCSs Lists the names of existing user coordinate systems. The
list is filtered using the wild-card combinations you enter (wild-card characters
accepted by the UCS command are valid).
Current Uses the XY plane of the current UCS to create a profile view.
Enter the name of the UCS you want to use and the scale of your view. Entering
a scale is equivalent to zooming your viewport by a factor relative to paper
space.
The center is based on the current model space extents.
Ortho
Creates a folded orthographic view from an existing view.
Once you select the side of the viewport you want to use for projecting the
new view, a rubber-band line perpendicular to the side of the viewport helps
you locate the center of the new view.
SOLVIEW | 1815