2011

and a layer where you can place dimensions that are visible in individual
viewports, view name-DIM.
WARNING The information stored on these layers is deleted and updated when
you run SOLDRAW. Do not place permanent drawing information on these layers.
NOTE SOLVIEW is defined by the acsolids.arx application and is intended to be
used only interactively.
UCS
Creates a profile view relative to a user coordinate system. If no viewports
exist in your drawing, the UCS option is a good way to create an initial
viewport from which other views can be created. All other SOLVIEW options
require an existing viewport.
You have the option of using the current UCS or a previously saved one as
the profile plane. The viewport projection is created parallel to the XY plane
of the UCS with the X axis facing right and the Y axis upward.
Named Uses the XY plane of a named UCS to create a profile view.
Enter the name of the UCS you want to use and the scale of your view. Entering
a scale is equivalent to zooming your viewport by a factor relative to paper
space.
The center is based on the current model space extents.
1814 | Chapter 19 S Commands