2011

Adds a jogged segment to a section object.
Access Methods
Button
Ribbon: Mesh Modeling tab ➤ Section panel ➤ Section Plane Jog
Shortcut menu: Right-click a section line ➤ Add Jog to Section
Summary
You can insert a jog, or angle, into a section object as you create it. The jog is
created on the section line. The jogged segment is created at a 90-degree angle
to the section line.
NOTE The SECTIONPLANEJOG command was previously called JOGSECTION.
Entering jogsection at the Command prompt runs SECTIONPLANE JOG.
List of Prompts
The following prompts are displayed.
Select section object Specifies which section line to modify.
Point on the section line to add jog Specifies the location of the jog.
SECTIONPLANEJOG | 1707