2011

Specify other corner: Specify a point
Plot Offset
Specifies an offset of the plot area relative to the lower-left corner of the
printable area or to the edge of the paper, depending on the setting made in
the Specify Plot Offset Relative To option (Options dialog box,
Plot and Publish
tab
). The Plot Offset area of the Plot dialog box displays the specified plot
offset option in parentheses.
The printable area of a drawing sheet is defined by the selected output device
and is represented by a dashed line in a layout. When you change to another
output device, the printable area may change.
You can offset the geometry on the paper by entering a positive or negative
value in the X and Y offset boxes. The plotter unit values are in inches or
millimeters on the paper.
Center the Plot
Automatically calculates the X and Y offset values to center the plot on the
paper. This option is not available when Plot Area is set to Layout.
X
Specifies the plot origin in the X direction relative to the setting of the Plot
Offset Definition option.
Y
Specifies the plot origin in the Y direction relative to the setting of the Plot
Offset Definition option.
Plot Scale
Controls the relative size of drawing units to plotted units. The default scale
setting is 1:1 when plotting a layout. The default setting is Fit to Paper when
plotting from the Model tab.
Fit to Paper
Scales the plot to fit within the selected paper size and displays the custom
scale factor in the Scale, Inch =, and Units boxes.
Scale
Defines the exact scale for the plot. Custom defines a user-defined scale. You
can create a custom scale by entering the number of inches (or millimeters)
equal to the number of drawing units.
NOTE You can modify the list of scales with SCALELISTEDIT.
1466 | Chapter 16 P Commands