2011

Select one of more pages from the PDF file
Displays all of the pages that are found in the PDF file. If the PDF file only
contains a single page, that page is listed. You can select multiple pages by
holding Shift or Ctrl and selecting the pages to attach.
Path Type
Select the full (absolute) path, the relative path to the PDF file, or No Path,
and the name of the PDF file. For the No Path option, the PDF file must be
located in the same folder as the current drawing file.
Insertion Point
Specifies the insertion point for the selected PDF file.
Specify On-Screen
Directs input at the Command prompt or the pointing device.
X
Sets the X coordinate value.
Y
Sets the Y coordinate value.
Z
Sets the Z coordinate value.
Scale
Specifies the scale factor of the selected PDF underlay.
If
INSUNITS is set to “unitless” or if the underlay does not contain resolution
information, the scale factor becomes the underlay width in AutoCAD units.
If INSUNITS has a value such as millimeters, centimeters, inches, or feet, and
the underlay has resolution information, the scale factor is applied after the
true width of the underlay in AutoCAD units is determined.
Specify On-screen
Inputs information at the Command prompt or with the pointing device. If
Specify On-Screen is cleared, enter a value for the scale factor.
Scale Factor Field
Enter a value for the scale factor.
Rotation
Specifies the rotation angle of the selected DWF underlay.
1430 | Chapter 16 P Commands