2011

When you reach a logical extent (edge of the drawing space), a bar is displayed
on the hand cursor on that edge. Depending on whether the logical extent is
at the top, bottom, or side of the drawing, the bar is either horizontal (top or
bottom) or vertical (left or right side).
When you release the pick button, panning stops. You can release the pick
button, move the cursor to another location in the drawing, and then press
the pick button again to pan the display from that location.
To stop panning at any time, press Enter or Esc.
-PAN
Quick Reference
See also:
■ Pan or Zoom a View
List of Prompts
The following prompts are displayed.
Specify base point or displacement: Specify a point
You can specify a single point, indicating the relative displacement of the
drawing with respect to the current location, or (more commonly) you can
specify two points, in which case the displacement is computed from the first
point to the second point.
If you press Enter, the drawing is moved by the amount you specified in the
Specify Base Point or Displacement prompt. For example, if you specify 2,2
at the first prompt and press Enter at the second prompt, the drawing is moved
2 units in the X direction and 2 units in the Y direction. If you specify a point
at the Specify Second Point prompt, the location of the first point is moved
to the location of the second point.
-PAN | 1401