2011

The Units page of the Quick Setup wizard includes the same formats. See
Specify Units and Unit Formats for more information.
The unit precision specifies the number of decimal places or the fractional
size for displaying linear measurements.
Angle
Indicates the format in which you enter angles and in which the program
displays angles.
Decimal Degrees Displays partial degrees as decimals.
Deg/Min/Sec Displays partial degrees as minutes and seconds.
Grads Displays angles as grads.
Radians Displays angles as radians.
Surveyor Displays angles in surveyor's units.
Angle Measure
Indicates the direction of the 0 angle for the entry of angles. When you enter
an angle value, the angle is measured either counter-clockwise or clockwise
from the compass direction that you select on this page. You control the
counterclockwise/clockwise direction on the Angle Direction page.
East Specifies the compass direction east as the 0 angle.
North Specifies the compass direction north as the 0 angle.
West Specifies the compass direction west as the 0 angle.
South Specifies the compass direction south as the 0 angle.
Other Specifies a direction other than east, north, west, or south. Enter a
specific compass angle to treat as the 0 angle.
Angle Direction
Indicates the direction from the 0 angle in which you enter and in which the
program displays positive angle values: counterclockwise or clockwise.
Area
Indicates the width and length in full-scale units of what you plan to draw.
This setting limits the area of the drawing covered by grid dots when the grid
is turned on. When limits checking is turned on with the LIMITS command,
this setting also restricts the coordinates you can enter to within the rectangular
area. You can change the drawing area and turn limits checking on and off
with the LIMITS command.
1276 | Chapter 14 N Commands