2011

Number of Rows/Columns Specifies the number of rows and columns in the
array.
Distance Between Rows Specifies the distance (in units) between rows. You
can use the pointing device to specify the distance between rows, or specify
two points to define a box whose width and height represent the distance
between rows and between columns.
Distance Between Columns Specifies the distance (in units) between columns.
Corner Sets the scale factor by using the block insertion point and the opposite
corner.
■
Specify Rotation Angle on page 1166
■
Number of Rows/Columns on page 1167
■
Distance Between Rows on page 1167
■
Distance Between Columns on page 1167
XYZ Sets X, Y, and Z scale factors.
■
X Scale Factor on page 1166
■
Corner on page 1167
■
Specify Rotation Angle on page 1166
■
Number of Rows/Columns on page 1167
■
Distance Between Rows on page 1167
■
Distance Between Columns on page 1167
Basepoint
Temporarily drops the block in the drawing where it is currently positioned
and allows you to specify a new base point for the block reference as it is
dragged into position. This does not affect the actual base point defined for
the block reference.
Scale
Sets the scale factor for the X, Y, and Z axes. The scale for the Z axis is the
absolute value of the specified scale factor.
■ XYZ on page 1167
■
Specify Rotation Angle on page 1166
■
Number of Rows/Columns on page 1167
MINSERT | 1167