2011

<None> Indicates an individual markup that does not yet have an assigned
status. This is the default status for new markups.
Question Indicates an individual markup that has an assigned status of
Question. When you open and view a markup, you can change the status to
Question if you need additional information about the markup.
For Review Indicates an individual markup that has an assigned status of For
Review. When you implement a markup, you can change the status to For
Review to indicate that the markup creator should review the changes to the
drawing sheet and the status of the markup.
Done Indicates an individual markup that has an assigned status of Done.
When a markup has been implemented and reviewed, you can change the
status to Done.
Markup Shortcut Menu Options (Markup Set Node)
Right-clicking a markup set node in the Markups area displays the following
shortcut menu options.
Open Markup DWF Opens the Open Markup DWF dialog box (a standard
file selection dialog box), in which you can select a DWF or DWFx file that
contains markups. When you click Open, the markups in the selected DWF
or DWFx file are loaded into the Markup Set Manager.
NOTE When opening a digitally signed DWFx file, a message box is displayed
that warns you about saving a new version of the file will invalidate the attached
digital signature.
Close Markup DWF Closes the selected marked-up DWF or DWFx and removes
it from the Markup Set Manager.
Save Markup History Changes Saves changes to the status of markups and
added comments to the marked-up DWF or DWFx file.
NOTE Saving a DWFx file that contains a digital signature will invalidate the
attached digital signature.
Markup Shortcut Menu Options (Drawing Sheet Node)
Right-clicking a drawing sheet node in the Markups area displays the following
shortcut menu options.
Open Sheet Opens the originating drawing file for that drawing sheet and
makes that layout the active layout in the drawing area.
Republish All Sheets Opens the Specify DWF File dialog box. Use this dialog
box to overwrite the previously published DWF or DWFx files, or create a
DWF or DWFx file.
1070 | Chapter 13 M Commands