2004

822 | Chapter 30 Publish Drawing Sets
See Also
“Configure a DWF6 Driver (Advanced)” on page 833
To create an electronic drawing set
1 With a drawing open and saved, on the Standard toolbar, click the publish
button.
2 In the Publish Drawing Sheets dialog box, the drawing layouts are shown
in the List of Drawing Sheets. To modify the list of drawing sheets, do any
of the following as needed:
■ Add Sheets. To add sheets from other drawings, click Add Sheets (or
drag drawings from the desktop). In the Select Drawings dialog box,
select drawings and then click Select to add them to the list of sheets in
the Publish Drawing Sheets dialog box. All of the layouts in a drawing
become individual sheets in the list of drawing sheets. You must
remove those you don’t want to become a part of the drawing set. Lay-
outs must be initialized before they can be published.
Note To include all layouts when you add sheets to a drawing set, make
sure the Include Layouts When Adding Sheets option on the shortcut
menu is checked.
■ Model Tab. If an unitialized Model layout is included, it will be marked
as Unitialized in the Status column on the List of Drawing Sheets. It can
be published if a page setup override is applied.
Note To include the Model when you add sheets to a drawing set, make
sure the Include Model When Adding Sheets option on the shortcut menu
is checked.
■ Remove Sheets. To remove sheets from the list, select one or more
sheets in the list, and then click Remove. To remove all sheets, click
Remove All.
■ Reorder Sheets. To reorder the sheets up or down one position in the
list, select a sheet and click either Move Up or Move Down. Sheets in
the drawing set are viewed or plotted in the order shown in the list.
■ Rename Sheets. To rename a sheet, select it in the list and right-click,
and then click Rename Sheet on the shortcut menu. Enter the new
sheet name.