2004

Table Of Contents
Create and Insert Symbols (Blocks) | 333
To specify whether changes are applied to existing block references
1 From the Modify menu, choose Object Attribute Block Attribute
Manager.
2 In the Block Attribute Manager, choose Settings.
3 In the Settings dialog box, do one of the following:
To apply changes to existing block references, select the
Apply Changes to Existing References option.
To apply changes only to new block insertions, clear the
Apply Changes to Existing References option.
4 Choose OK.
Modify II toolbar
Command line
BATTMAN
To highlight duplicate attribute tags in a block
1 From the Modify menu, choose Object Attribute Block Attribute
Manager.
2 In the Block Attribute Manager, choose Settings.
3 In the Settings dialog box, select Emphasize Duplicate Tags.
4 Choose OK.
Modify II toolbar
Command line
BATTMAN
To change the prompt order for attribute values
1 From the Modify menu, choose Object Attribute Block Attribute
Manager.
2 In the Block Attribute Manager, select a block from the Block list, or
choose Select Block and select a block in the drawing area.
For the selected block, attributes are listed in their prompt order.
3 To move an attribute up in the prompt order, select the attribute, and then
choose Move Up; to move an attribute down in the prompt order, select
the attribute, and then choose Move Down.
Note The Move Up and Move Down buttons are unavailable for attributes with
constant values (Mode=C).