2004

Draw Linear Objects | 265
To draw a line and arc combination polyline
1 From the Draw menu, choose Polyline.
2 Specify the start point of the polyline segment.
3 Specify the endpoint of the polyline segment.
■ Switch to Arc mode by entering a (Arc) on the command line.
■ Return to Line mode by entering L (Line).
4 Specify additional polyline segments as needed.
5 Press
ENTER to end or c to close the polyline.
Draw toolbar
Command line
PLINE
To create a wide polyline
1 From the Draw menu, choose Polyline.
2 Specify the start point of the line segment.
3 Enter w (Width).
4 Enter the starting width of the line segment.
5 Specify the ending width of the line segment using one of the following
methods:
■ To create a line segment of equal width, press ENTER .
■ To create a tapering line segment, enter a different width.
6 Specify the endpoint of the polyline segment.
7 Continue specifying segment endpoints as needed.
8 Press
ENTER to end, or enter c to close the polyline.
Draw toolbar
Command line
PLINE
To create a boundary polyline
1 From the Draw menu, choose Boundary.
2 In the Boundary Creation dialog box under Object Type, select Polyline.