2011

■ Carat (^) creates a tolerance stack, which is not separated by a line.
If you enter numbers separated by stack characters and then enter a
nonnumeric character or press SPACEBAR, the AutoStack Properties dialog
box is displayed.
5 In the AutoStack Properties dialog box, you can choose to automatically
stack numbers (not nonnumeric text) and to remove leading blanks. You
can also specify whether the slash character creates a diagonal fraction
or creates a vertical fraction. If you do not want to use AutoStack, click
Cancel to exit the dialog box.
6 Select the text that you want to stack, and click the Stack button on the
toolbar.
7 To save your changes and exit the editor, use one of the following
methods:
■ Click OK on the toolbar.
■ Click in the drawing outside the editor.
■ Press CTRL+ENTER.
To change stack properties
1 Double-click the multiline text object you want to edit.
2 In either the MTEXT ribbon contextual tab (Formatting tab drop-down)
or In-Place Text Editor, select the stacked text.
3 Right-click in the editor. Click Properties.
4 In the Stack Properties dialog box, change settings as needed.
5 To set properties for automatic stacking, click Autostack.
6 To save your changes and exit the editor, use one of the following
methods:
■ Click OK on the toolbar.
■ Click in the drawing outside the editor.
■ Press CTRL+ENTER.
To unstack text
1 Double-click the multiline text object you want to edit.
1330 | Chapter 29 Notes and Labels