2010
Table Of Contents
- Contents
- 1 Introduction
- 2 Get Familiar with the Work Area
- 3 Drawing Commands in AutoCAD Mechanical
- 4 Modify Drawings with Power Commands
- 5 Generate Standard Parts
- 6 Organize Objects with Layers
- 7 Create Hidden Lines
- 8 Reusable Detailing Tools
- 9 Power Dimensions
- 10 Add Part Lists and Balloons
- 11 International Drafting Standards
- Index
Insert Fasteners
In the standard part libraries, you can also find the most commonly used
fasteners for your assemblies. In this exercise, you insert a cylindrical pin into
the pin hole on the bracket.
Insert a Cylindrical Pin
1 Click Content tab ➤ Fasteners panel ➤ Cylindrical Pins .
2 Select the ISO 2338 pin.
3 Select the Front View.
4 Specify the insertion point as shown in the following image.
5 Enter 270 degrees for its rotation angle.
6 Select 3 mm for its diameter.
7 Click Finish.
8 Drag its length to approximately 12 mm on the bushing.
40 | Chapter 5 Generate Standard Parts