2010
Table Of Contents
- Contents
- 1 Introduction
- 2 Get Familiar with the Work Area
- 3 Drawing Commands in AutoCAD Mechanical
- 4 Modify Drawings with Power Commands
- 5 Generate Standard Parts
- 6 Organize Objects with Layers
- 7 Create Hidden Lines
- 8 Reusable Detailing Tools
- 9 Power Dimensions
- 10 Add Part Lists and Balloons
- 11 International Drafting Standards
- Index
Create Countersink Holes
Countersink holes are Power Objects or mechanical objects. Use AMCOUNTS2D
to create a countersink hole. You can quickly change the size of countersink
holes by using the Power Edit command.
Create a Countersink Hole
1 Click Content tab ➤ Holes panel drop-down ➤ Countersink .
2 Create a countersink hole with nominal diameter 26 mm, countersink
diameter 35 mm, and angle 90 degrees.
3 Specify its insertion point as shown in the following image.
4 Enter 30 for the hole length and 180 degrees for the rotation angle.
5 Enter 26 for the nominal diameter, 35 for the countersink diameter, and
90 degrees for the angle, and then click Finish.
6 The program creates a countersink hole.
18 | Chapter 3 Drawing Commands in AutoCAD Mechanical