2008

Table Of Contents
6 In the Construction Lines dialog box, choose the Parallel with Full
Distance icon.
7 Respond to the prompts as follows:
Select line, ray or xline: Select line c (1)
Specify insertion point or Distance (xx|xx|xx..) <10|20|30>:
Enter 3|9, press ENTER
Specify point on side to offset: Specify a point to the left of line c (2)
8 Insert the second set of parallel lines, and respond to the prompts as
follows:
Select line, ray or xline: Select line b
Specify insertion point or Distance (xx|xx|xx..) <3|9>:
Enter 4.5|9.5, press ENTER
Specify point on side to offset: Specify a point below line b (2)
9 Press ENTER.
134 | Chapter 7 Designing Levers