2009

Table Of Contents
3 In the Shaft Calculation dialog box, click the Strength button, and then
respond to the prompt as follows:
Specify calculation position on shaft or [Graph]:
Specify the notch at the end of the conical section (1) (do not select the endpoint
of the cylindrical shaft section)
NOTE This notch was selected because the calculation established that the
highest bending stress is close to this place.
The Strength Calculation dialog box opens.
Use the Strength Calculation dialog box to specify the properties of the
notch in more detail and display the strength values and factors.
Calculating Strengths of Shafts | 271