2009

Table Of Contents
To configure the snap options
1 Start the Power Snap Settings.
2 In the Power Snap Settings dialog box, in the Power Snap Configuration
list, select Settings 4 and specify:
Snap Modes: Endpoint, Midpoint, Intersection
Click OK
Save your file.
Configuring Shaft Generators
In the next steps, you start and configure the shaft generator.
To start and configure the shaft generator
1 Start the Shaft Generator command. On the command line, enter
AMSHAFT2D.
2 Respond to the prompts as follows:
Enter shaft component name <Shaft1>: Press ENTER
Specify starting point or select center line:
Enter 150,150, press ENTER
Specify centerline endpoint: Enter 240,150, press ENTER
238 | Chapter 11 Creating Shafts with Standard Parts