2009

Table Of Contents
4 Respond to the prompts as follows:
Specify first point: Select the first point (1)
Specify second point or Angle (xx|xx|xx..) <30|45|60>:
Move the cursor over line a and back to the rectangle until the Parallel symbol
appears, click (2)
5 Press ENTER to finish the command.
Now, you draw tangential circles between the diagonal C-line and the
right vertical line and lower horizontal line of the rectangle.
6 Start the Draw Construction Lines command. On the command line,
enter AMCONSTLINES.
The Construction Lines dialog box is displayed.
7 In the Construction Lines dialog box, choose the option next to the
Construction line circle tangent to 2 lines icon, shown below and click
OK.
8 Draw the two circles by responding to the prompts as follows:
Select first tangent: Select tangent point (1)
Select second tangent: Select tangent point (2)
Specify diameter: Enter 2, press ENTER
Select first tangent: Select tangent point (3)
Select second tangent: Select tangent point (4)
Specify diameter <2>: Enter 2, press ENTER
106 | Chapter 5 Designing Levers