6.0

Table Of Contents
640 | Chapter 21 Surfacing Wireframe Models
The blended surface should look like this.
3 Use CHPROP to move the surface to the INLET layer.
Join the lines to form the boundary of inlet E, and then create a trimmed planar
surface from the joined lines. Zoom in as needed to make line selection easier.
To create the inlet E trimmed planar surface
1 Use
AMJOIN3D to join selected lines to form the boundary for the inlet E sur-
face.
Desktop Menu Surface Edit Wireframe Join
In the Join3D dialog box, specify:
Mode: Automatic
Output: Polyline
Gap Tolerance: Enter .01
Choose OK.
2 Respond to the prompts as follows:
Select start wire or: Select polyline (1)
Select wires to join: Select wires (2) through (4)
Select wires to join: Press
ENTER
Reverse direction? [Yes/No] <No>: Press ENTER
1
2
3
4