6.0

Table Of Contents
Joining Surfaces on Complex Shapes | 639
To create the inlet D blended surface
1 Use
BREAK to break the polyline into two line segments, responding to the
prompts.
Desktop Menu Modify Break
Select object: Select polyline (1)
Specify second break point or [First point]: Enter f
Specify first break point: Enter int
of: Select polyline (2)
Specify second break point: Enter @
Check the grip points of the line segments after you break the polyline.
2 Use
AMBLEND to create the inlet D surface, responding to the prompts.
Desktop Menu Surface Create Surface Blend
Select first wire: Select wire (1)
Select second wire: Select wire (2)
Select third wire: Select wire (3)
Select fourth wire: Select wire (4)
Make selections in order, selecting opposite wires in pairs.
1
2
2
4
1
3