6.0

Table Of Contents
638 | Chapter 21 Surfacing Wireframe Models
To create the inlet C ruled surface
1 Use
AMRULE to create the inlet C surface, responding to the prompts.
Desktop Menu Surface Create Surface Rule
Select first wire: Select wire (1)
Select second wire: Select wire (2)
Your model should look like this.
2 Use
CHPROP to move inlet B and C surfaces to the INLET layer.
Save the file.
Next, you create inlet D, a surface blended from the edges of inlet B and C
surfaces and the polyline that defines the edge of inlet E. You may need to
rotate the model to show the intersection clearly.
1
2