2011

2 In the drawing area, select the polygon to edit.
3 Enter a.
4 Select the polygon or closed polyline to add to the polygon.
The boundary is added to the polygon and assigned an inner or outer
boundary type based on its relationship to the rest of the object
5 Repeat Step 2 to add any other boundaries.
6 When the selection is completed, you can rebalance the polygon by
entering r.
To delete boundaries
1 At the Command prompt, enter
mapmpedit (page 1818).
2 Select the polygon to edit.
3 Enter d to delete the boundary, or enter c to delete the boundary from
the polygon but preserve it as an object.
4 Click a boundary object to delete from the polygon.
The boundary is removed from the polygon.
5 Repeat Step 2 to delete any other boundaries.
6 When the selection is completed, you can enter r to rebalance the
polygon.
To move boundaries
1 At the Command prompt, enter
mapmpedit (page 1818).
2 Select the polygon to edit.
3 Enter m.
4 Click a boundary object to move within the polygon.
Any nested boundaries within the boundary are also selected.
5 Click in the drawing to specify the base point.
6 Click in the drawing to specify the displacement point.
7 Repeat these steps to move any other boundaries.
964 | Chapter 6 Creating and Editing Data