2011

NOTE To edit a topology, use the AutoCAD Map 3D topology edit commands.
When you edit a topology, the topology must be loaded from the current drawing.
To add an object to a topology, the current drawing must be the drawing where
the topology was created.
NOTE This procedure is for drawing objects only. There is no equivalent for
geospatial feature data.
To edit a topology
■
To edit a node (page 860)
■ To reposition a node at the end point of a link (page 863)
■
To divide a polygon into two smaller polygons (page 867)
■
To change the appearance of points (page 870)
■
To specify the direction for a link (page 847)
■
To edit the resistance of a link or node in a network topology (page 850)
■ To create a node on an existing link (page 878)
■
To create a link and add it to a topology (page 880)
■ To add a polygon to a polygon topology using existing linework (page 884)
■ To create centroids for polygons and closed polylines (page 887)
■
To delete a link, node, or polygon (page 889)
■
To update a topology (page 892)
■ To retrieve objects to edit (page 894)
Quick Reference
DDPTYPE
Specifies the display mode and size of point objects
Setup menu ➤ More Formatting Options ➤ Point
Style
Menu
DDPTYPECommand Line
854 | Chapter 6 Creating and Editing Data