2011

See also:
■ Overview of Cleaning Up Maps (page 766)
■ Step 2: Setting Cleanup Options (page 771)
■ Overview of Cleanup Actions (page 788)
NOTE This procedure is for drawing objects only. There is no equivalent for
geospatial feature data.
To extend objects to their apparent intersection
1 Click Tools tab ➤ Map Edit panel ➤ Clean Up.
2 On the Select Actions page, in the Cleanup Actions list, click Apparent
Intersection. Click Add.
3 In the Select Actions list, click Apparent Intersection to display the cleanup
parameters for this action.
4 Under Cleanup Parameters, set the Tolerance to a value slightly higher
than the radius of a circle that includes the endpoints of the objects and
their projected intersection point. (Imagine a point where the objects
would intersect if they extended along their natural paths).
You can enter a value into the Tolerance box or click Pick to go to the
map and select two points that define the tolerance to use.
If AutoCAD Map 3D does not find an apparent intersection, try increasing
the Tolerance value.
Cleaning Up Drawing Data | 803